BUILDING
SYSTEM PROJECTS HISTORY PRODUCTS
GULF SHORES VILLA CONTACT US
|
|
| This house was under construction in an older neighborhood in Birmingham, AL. As you can see, the blocks are guided into place by the 'handles' of the block below it. Only one man is needed to position the block as it is lowered. Notice the scored concrete floor. It was poured after the first two rows of blocks were in place and will be given a surface treatment so that it resembles stone or tiles. This particular house had most of it's first floor electrical outlets mounted flush in the poured floor, but you can simply drop PVC pipe into the wall cavities to run your wiring to wall receptacles. | |
|
DAC-ART construction is easy. The components are
stacked without mortar. The wire handles used to lift and place the blocks are designed to
allow for perfect alignment of the next block stacked on top. Buildings go up fast.
DAC-ART blocks have subtle variations of tint and purposeful surface 'imperfections' to add to the look of stone. After they are in place, a mortar mixture can be added to give them a 'set in mortar' look. Interior walls can be finished out in conventional products such as gypsum board or paneling, or left as-is for a European stone look. |
|
|
|
|
|
Cornices are normally difficult to build. A great deal of scaffolding is usually needed. Many working trips around the structure are normally required to build the shapes and finishes needed for an attractive cornice. With DAC-ART however, the lift simply sets another component. All the shapes and finishes are already on the component. The cornice component also has the same cavity and connection design that is the hallmark of DAC-ART: each side of a component that abuts another component has the typical DAC-ART opening to allow the internal concrete pour to make its connection to the other component with full continuity. |
Page 2 Page 3 Page 4 Page 5 Mosaics Page 7 Page 8 Page 9 Page 10 Page 11
Page 12 Page 13 Page14 Mosaics Details 1 & 2 & 3 Interior & Chandelier